Mechanically Attached System Information

Mechanically-Attached System uses polyester reinforced PVC roof membrane. Available in three widths; 5-feet, 6.5-feet and 10-feet. The membrane is fastened directly into the structural deck or the structural framing in any mechanically-attached configuration.

System Description
The membrane is fastened in the seam overlap along one long side of the membrane directly into the roof deck. The adjacent membrane panels are then heat-welded with a hot-air welder. The advantage of this type of system is speed of installation and simplicity of design. This System is often the most cost-effective mechanically-attached system available using PVC membrane.

This system utilizes a high-strength polyester reinforcement that allows the system to exceed Factory Mutual requirements for wind uplift testing. The manufacturing process imparts dimensional stability and eliminates water-wicking by the reinforcement. The membrane is lacquer-coated on the weathering surface for dirt resistance. It is available in white and in other colors.

Thank you for choosing Diamond Roofing, Inc. for your roofing and waterproofing needs.

PVC membrane is rolled out and laid flat on substrate surface	Screws and plates are used to fasten insulation board
	Preformed flashings are hand welded
Membrane is overlapped and welded to form a watertight seam
Hand Weld	Auto Weld